Культура

Also, during construction, there is always a risk of formwork fire, so it is better to use reinforced material. In order to avoid fire and reduce its risk,...

Pouring concrete solution of polystyrene formwork In the process of filling with concrete solution, you can stain the wall from the outside, but since it will be finished...

This is done by two methods: On the walls of formwork blocks, elastic plaster smears. Applying special glue, apply fiberglass. In fact, the formwork of extruded polystyrene foam...

Precautions During construction, it is necessary to take into account the fact that this material does not make mechanical exposure, since the formwork wall can be accidentally pierced....

Installation of formwork from polystyrene foam The structure of the structure occurs every three rows, and the rods are laid on the door and window jumpers. In the...

In the event that the installation of the blocks is carried out not on the built foundation, but a specially erected base for them, then 12 mm rods...

This is important! After laying out the first layer in the recesses, which are located in the jumper of the blocks, 8 mm reinforcing rods (in two rows)...

During construction, it cannot be used concrete with a content of 8 mm crushed stone. Installation of formwork Initially, any waterproofing material is laid on the base of...

The fragility of the blocks - at any time can crack; It is impossible to carry out work in the winter; The structure must be grounded or poured;...

Foam of polystyrene foam Among the shortcomings we highlight: Combustibility - formwork easily ignites; Toxicity - it is possible to obtain poisoning;